HGM125 Micronizer Mill is the biggest Micronizer Mill of HGM Series . HGM125 Micronizer Mill is the euqipment for producting fine and ultra fine powder of non-inflammable, non-explosive and brittle materials with Moh's under six, the moisture under 5% such as calcite, chalk, limetone, domolite, kaolin, bentonite, talc, mica, magnesite, illite, pyrophyllite and vermicullite, sepiolite, attapulgite, rectorite, diatomite, barite, guypsum, gypsum, alunite, graphite, fluorite, rock phosphate, kalium ore, pumice, etc., totally more than 100 kinds fo materials.
Working principle of HGM125 Micronizer Mill:
1) After crushed by hammer crusher, the large materials become smaller pieces and are sent to the micro powder grinding mill.
2) When the micro powder grinding mill is at work, the granulated materials are crushed and grinded by the rollers into particles below 47micron.
3) The high-pressure air blower constantly inhales air within the micro powder grinding mill.
4) Along with the high speed airflow, micronized materials are brought to the classifier.
5) The qualified particles are screened and driven into the cyclone powder collector, finally exit from the discharging valve at the bottom;
6) A small proportion of the fine powders, with airflow, moving to the dust cleaner. Filtered clean air will be emitted from the air outlet of muffler in the end.
Features and advantages of HGM125 Micronizer Mill:
Under the same finished that final size and the same motor powder, the capacity of Micronizer is twice as much as jet mill, mixing grinder and ball mill, and energy consumption decreased 30%.
Long lifecycle of spare parts
The ring and roller are forged by special material with high utilization. Under the same grinding material and finish special size, the lifecycle of spare parts is about one year, wihicn is 2-3times longer that impact mill or turbo mill. Furthermore, the lifetime can reach 2-5 years for grinding calcite carbonate.
High satety and reliablity
As no rolling bearings or screws in grinding caving there are no problems caused by bolts shedding or rapid wear of bearings and seal components.
High fineness and flexible adjustment
The final fineness of the grinding materials can be ajusted between 325 meshes and 2500 meshes(47-5micron), and the product fineness can reach D97≤5μm.
The application of pulse bag filter and muffler greatly alleviates dust polltion and noise.
Main Specification of HGM125 Micronizer Mill:
|Main Shaft Speed(r.p.m.)||230～240||200～220||180～200||135～155|
|Outlet Size (L*W*H, m)||13.9*4*6.2||14.7*4.8*7.2||18*4.6*8.6||14*9*10.25|
Note: This specification is just referencing, any changes are subject to the products.
Shanghai clirik machinery co., LTD.
Phone: 4008-168-355; 0086-21-20236178
Contact person: Ammy
Address: No.19 Fuqing Rd, Pudong New Area, Shanghai201201, China.